Has anyone run into an issue where the starter stays spinning after the engine fires? 07 5.7 car engine 74 Plymouth Duster
top of page

THE
HEMI SWAP
COMMUNITY
Welcome to the Hemi Swap Community! We want this to be an open forum where anyone can ask anything about the Hemi engine and doing Hemi Swaps. We find the information can be scattered all over the internet and want this to be a centralized place where we can talk amongst each other and share our questions and answers that may be able to help others going through similar Hemi swap situations. Please be kind to others and help out where you can while getting the information you need. Blake and Mike will be admins and answering questions here as well!
Hemi Swap The World!
-DIYHEMI
Look back on my other posts also Ed. I think on "Starter " I really need to get my video up as Both guy's from DIY are really helpful.
Hi Ed. My Starter did the same. To solve it I had W21 wire connected to my 12 volt post side of my key switch. It has to go directly to the battery. I know it sounds strange but that's where it needs to be..
I saw a similar post. Is the issue the neutral start wiring? Or a ground
I’ll check! Thanks
Is your 12v key on and starter wire tied together?