Welcome to the Hemi Swap Community! We want this to be an open forum where anyone can ask anything about the Hemi engine and doing Hemi Swaps. We find the information can be scattered all over the internet and want this to be a centralized place where we can talk amongst each other and share our questions and answers that may be able to help others going through similar Hemi swap situations. Please be kind to others and help out where you can while getting the information you need. Blake and Mike will be admins and answering questions here as well!
Hemi Swap The World!
-DIYHEMI
Got the Hemi in the Winni. Fits great!! the only issue is the lower rear pass a arm mount is right where the starter is. Its not to far from fitting though. Ive planned on making the mount removable there so that the engine would drop out the bottom... I fabbed all the suspension around the original 318... I know ....
What transmission are you using?
@Blake Andermann I believe Nag 1? It's out of a 2007 chrysler 300
Do you have room on the opposite side of the engine? Jeep NAG1 transmissions had the starter on the opposite side just like the 318. You can buy just the jeep bellhousing for a NAG1 and switch to LH mounted starter
Well the drivers a arm is in the exact same position on that side so if the starter is the same then it won't fit any better. But is it the same starter as mine? I would thinknif it was then the starter would be mounted upside down from thw way it is on mine and that would probably work