Hello new member here. I am swapping an 04 hemi into a 95 Dakota with an 06 jeep wire harness, we will be using your harness and computer to button up the wiring side. Can we run the fans off of the truck power distribution block, if so will the computer control the fans? Also the motor has had a comp cams shaft installed, its not wild by any means just a step or two above stock, would we need to get a tuner or is there software we can procure to tune it with. It is a truck motor with a mopar performance car intake and timing cover. Just a couple questions before we make the order from your store. Thanks guys. Glad to be a part of the community. Looking forward to future swaps and using your products in the next project. 69 dart custom is next on the list.

THE
HEMI SWAP
COMMUNITY
Welcome to the Hemi Swap Community! We want this to be an open forum where anyone can ask anything about the Hemi engine and doing Hemi Swaps. We find the information can be scattered all over the internet and want this to be a centralized place where we can talk amongst each other and share our questions and answers that may be able to help others going through similar Hemi swap situations. Please be kind to others and help out where you can while getting the information you need. Blake and Mike will be admins and answering questions here as well!
Hemi Swap The World!
-DIYHEMI
disregard the above questions, will it matter that we went with a car intake and timing cover. It shouldnt I would think right